Von Audio System gibt es eine Vielzahl an Nachrüstlautsprechern für Audi. Wir schaffen den Überblick und testen das RFIT Set für den A6 C8.
>> Mehr erfahren>> Alle anzeigenMit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenKategorie: Hifi sonstiges
Ausstattungsliste: Creek Sequel-mk4
Specification | |
Type | Plug-in Phono Pre-Amplifier |
Input Impedance | 47k Ohms |
Cartridge compatibility | Medium to high output range MM, from 2.2mV to 6.5mV |
Power output @ 1% THD | >120 Watts into 8 Ohms, both channels driven (31V RMS) Low output MM or high output MC cartridges from 0.8mV to 2.2mV - 47k Ohms input impedance only |
Frequency Response | 10 Hz to 20 kHz +/- 0.5dB |
Signal to noise ratio | >80dB at 40dB gain or >70dB at 50dB gain |
THD | <0.005% |
Maximum output | 10V RMS, limited by its regulated power supply voltage |
Switchable options | Piano key (DIP) switch on-board selects the following |
Gain 1 | 40dB (x100) for medium to high output MM |
Gain 2 | 50dB (316) for high output MC and low output MM |
Capacitance | 100pF or 200pF |
Low Frequency filter | RIAA flat or IEC low frequency 20Hz roll-off (7950 µs) |