390_22002_2
Topthema: Sound im Audi
Audio System RFIT Audi A6 C8 Evo2 – 20er System für Audi A6
Von Audio System gibt es eine Vielzahl an Nachrüstlautsprechern für Audi. Wir schaffen den Überblick und testen das RFIT Set für den A6 C8.
>> Mehr erfahren>> Alle anzeigen
462_22882_2
Topthema: Feurig
High-End-Standbox mit ESS AMT
Mit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenKategorie: Profi- / Musiker-Equipment
Ausstattungsliste: Manley STEELHEAD RC
Ausstattung & technische Daten
| Specification | |
| Type | PHONO STAGE WITH REMOTE CONTROL |
| Vacuum tube complement | 6922 SOVTEK Russian x 2 (gain) plus JAN NOS GE 7044 or 5687 x 4 (output buffers) |
| Fuse type and ratings @ 117 VAC operation | 1.5 Amp 3AG slow-blow mains fuse 0.5 Amp 3AG slow-blow logic fuse |
| Fuse type and ratings @ 230 VAC operation | 0.75 Amp 3AG slow-blow mains fuse 0.25 Amp 3AG slow-blow logic fuse |
| Moving Magnet input impedance | 5-step user adjustable via fixed low-noise resistors. 25, 50, 100, 200 and 47000 Ohms. |
| Moving Coil input impedance | 5-step user adjustable via multi-tap autoformer: 25, 50, 100, 200 and 400 Ohms. |
| Input Termination Capacitance | Front Panel Selectable in 10 picofarad steps from 10 to 1100 pF (1.1nF) Residual input capacitance less than 40 pF. |
| Gain | 4-step user adjustable, 50, 55, 60 and 65 dB active gain at 1 kHz referred to the FIXED output jack into a 10 kOhm load. Additional gain available via the MC inputs step-up autoformer. See Owners Manual for discussion. |
| Deviation from RIAA curve | Less than +0.5 / -0.3 dB from 20 Hz to 20 kHz at any gain setting. Typically less than ±1 dB from 10 Hz to 100 kHz |
| Inter-channel differential phase | Less than 4 degrees from 20 Hz to 20 kHz at any gain setting. Typically less than 2 degrees. |
| Inter-channel differential gain | Less than ±0.5 dB from 20 Hz to 20 kHz at any gain setting. |
| Dynamic Range | 101 dB @ 1 kHz, 1% THD measured with 200 Ohm source, 47 kOhm input, @ 55dB Gain 97 dB @ 1 kHz, 0.1% THD |
| THD | 0.0042% at 1V output @1kHz |
| REMORA RF REMOTE | controls motorised volume control up/down functions; uses 9v battery |
| Maximum MM input level | 50 mVrms @ 1KHz for an output of 17 Vrms or -23.8 dBu @ 1KHz for an output of +27 dBu @ 1.5% THD |
| Maximum MM input level | 93 mVrms @ 1KHz for an output of 29 Vrms or -18.4 dBu @ 1KHz for an output of +32.3 dBu @ 10% THD |
| Maximum MC input level | 39 mVrms @ 1KHz for an output of 17 Vrms or -26 dBu @ 1KHz for an output of +27 dBu @ 1.5% THD |
| Maximum MC input level | 72 mVrms @ 1KHz for an output of 29 Vrms or -20.6 dBu @ 1KHz for an output of +32.3 dBu @ 10% THD |
| Maximum LINE input level | 26.5Vrms @ 1KHz for an output of 22.8Vrms or +30.6dBu @ 1KHz for an output of +29.3dBu @ 0.07% THD |
| Maximum Output | +27dBm @ 1KHz with 3% THD into 100 kOhm load |
| FIXed Output impedance | 150 Ohms. Minimum suggested load greater than 1500 Ohms. |
| VARIable Output impedance | 75 Ohms. Minimum suggested load greater than 600 Ohms. |
| Power consumption | 100 watts |
| Outboard Power Supply | is factory set for 100V, 120V or 220-240VAC operation for original destination country |
| Operating Mains Voltage | 120 to 240VAC operation changeable with power transformer re-wiring via internal switch and fuse value change. 100VAC operation changeover achieved via rewiring of power transformer PCB. |
| Mains Voltage Frequency | 50~ 60Hz |
| PSU Regulation good for 65% rated voltage | 75VAC for 117V unit or 150VAC for 234V wired unit. |
| Unit weight | Steelhead: 15 lbs. |
| PSU: 18 lbs. | |
| Chassis dimensions | Steelhead: 19 wide x 3.5 tall x 15.5 deep |
| PSU: 13.5 wide x 4.5 tall x 11.375 deep | |
| PSU umbilical cord length | 5 1/2 feet approx. 1.65m |
