Es gibt Lautsprecher und dann gibt es noch die LS3/5A. Sie spaltet sowohl ihre Hörer, als auch die, die sie gar nicht kennen. Warum das so ist? Nun, dafür muss man sich vor allem anschauen und natürlich hören, was sie kann und nicht, was sie nicht kann.
>> Mehr erfahren>> Alle anzeigenMit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenKategorie: Profi- / Musiker-Equipment
Ausstattungsliste: Quested Monitoring Systems S7R
TECHNICAL SPECIFICATION | |
Dimensions | 244(w) x 347(h) x 302(d) mm |
Weight | 11.7 kg / 25.5 lb |
Drivers | Bass cone – 1 x 165 mm (6 ½”) |
High Frequency | Soft dome – 1 x 28 mm (1 ⅛”) |
Maximum SPL | 105 dB continuous pink noise @ 1 m LEQ 1 minute. 111 dB per pair pink noise @ 1m Leq 1 minute |
Frequency Response | 68 Hz-20 kHz ± 2 dB / 58 Hz-22kHz -6 dB |
Connector | XLR and ¼ inch Jack combo socket |
Impedance | 10k W electronically balanced with RF filters |
Wiring | Pin 1 ground Sleeve |
Pin 2 hot Tip | |
Pin 3 cold Ring | |
Sensitivity | -12 dBu to +6 dBu for 96 dB SPL @ 1 m set by 10 position rotary switch on rear |
Subsonic | -3dB @ 30 Hz, 24dB/oct |
Ultrasonic | -3dB @ 75kHz, 4dB/oct |
Crossover | 1k19 |
LF EQ | -2/-4 @ 65 Hz |
HF EQ | +/- 2dB @ 10 kHz |
POWER AMPLIFIER | |
LF output power | 120W RMS continuous (Note 1) |
HF output power | 70W RMS continuous (Note 1) |
THD | 0.03% at levels up to 1 dB below clip, 20 Hz-20 kHz. Typ 0.005% @ 1kHz. |
Hum & Noise | > -100 dB referred to clip |
Note | The continuous rating is for a period not exceeding 5 minutes with unrestricted airflow (100 mm clearance) around the amplifier heatsinks and an ambient temperature not exceeding 30ºC. |
INDICATORS | |
Power on | Front mounted green LED indicates power applied. |
Clip | Red LED 2 dB before amplifier clip. |
POWER REQUIREMENTS | |
Voltage | Set by internal plugs: nominal 115V or 230V @ 50-60 Hz AC 230V setting: min 160V; restricted output power: max 255 AC 115V setting: min 80V; restricted output power: max 127V |
CONSUMPTION | |
Quiescent | 18W |
Typical use | 75W (average music) |
Max | 140W (average music) |
Note | 0 dBu = 775 mV into open circuit |