562_24275_2
Topthema: OLED-TV · Philips 55OLED810
Adaptive Intelligenz
Die 800er Serie von Philips ist preislich deutlich unter den edlen OLED+ Modellen angesiedelt und erfreut sich daher hoher Beliebtheit. Dennoch bringt das brandneue 2025er Modell OLED810 einen Großteil der Technologie aus der Topserie mit.
>> Mehr erfahren>> Alle anzeigen
563_24276_2
Topthema: Soundbar · Canvas HiFi Canvas
Kann das was?
Bereits im Januar haben wir Ihnen die Canvas HiFi, die Mutter aller Soundbars vorgestellt. Nun hat der Hersteller an entscheidender Stelle nachgelegt – beim Klang.
>> Mehr erfahren>> Alle anzeigenKategorie: Profi- / Musiker-Equipment
Ausstattungsliste: Quested Monitoring Systems SB10R
Ausstattung & technische Daten
| TECHNICAL SPECIFICATION | |
| Dimensions | Cabinet 600(w) x 332 (h) x 300(d) mm |
| SBC250 Controller – 1U case 270mm deep | |
| Weight | Cabinet – 19.8 kg / 43.4 lb |
| SBC250 Controller – 5.5 kg / 12 lb | |
| Drivers | Bass cone 1 x 250mm (10”) |
| Maximum SPL | 116 dB continuous pink noise @ 1m Leq 1 minute half space |
| Frequency Response | User Adjustable. 25 Hz-200 Hz ± 2 dB / 17 Hz-200 Hz -6 dB |
| Connector | 2 off XLR and ¼ inch jack combo socket |
| Impedance | 10k W electronically balanced with RF filters |
| Wiring | Pin 1 ground Sleeve |
| Pin 2 hot Tip | |
| Pin 3 cold Ring | |
| Outputs | Left and Right Monitor 2 off XLR type male left & right outputs |
| Impedance | 100 ohm electronically balanced |
| Sub Bass Output | 1 pair binding posts |
| Filters | Left & Right Input Summed to Sub Output |
| Subsonic/High Pass | -3dB @ 14Hz, 24dB/oct or -3dB @ 28Hz, 24dB/oct (set by internal jumper) |
| Low Pass | -3dB @ 40Hz to 135Hz, externally adjustable @ 24db/oct or full range on CH A Left & Right Input to Left & Right Output |
| Ultrasonic | -1dB @ 100k |
| High Pass | -3dB @ 40Hz to 135Hz, externally adjustable @ 24db/oct or full range on CH A |
| POWER AMPLIFIER | |
| THD | 210W rms continuous |
| 0.03% at levels up to 1dB below clip, 20Hz – 120Hz typ | |
| 0.005% @ 20W rms 100Hz | |
| Hum & Noise | -100 dB referred to clip |
| Power Requirements | Set by internal plug: normal 115V or 230V setting: Min 160V (restricted output power): Max 255V 115V setting: Min 80V (restricted output power): Max 127V |
| CONSUMPTION | |
| Quiescent | <30Wv |
| Typical use | 50W |
| Max | <200W |
| Note | 0 dBu = 775 mV into open circuit |
| CONTROLS | |
| Controls | Crossover Frequency 40 – 135Hz, front panel pot |
| Test (Band limited pink noise), front panel recessed switch (LED indicates when on) | |
| Sub bass bypass, front panel switch (LED indicates when bypassed) | |
| Sub Gain –14 to +6, front panel pot (Sub level indicated with LED Meter) | |
| Sub Phase, front panel pot | |
| Sub Polarity, front panel recessed switch (LED indication for positive and negative polarity) | |
| Power, front panel switch | |
| Left channel sub filter bypass, rear mounted recessed Switch | |
| Subsonic filter 14 or 28Hz, Internal jumpers | |
