Mit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenEs gibt Lautsprecher und dann gibt es noch die LS3/5A. Sie spaltet sowohl ihre Hörer, als auch die, die sie gar nicht kennen. Warum das so ist? Nun, dafür muss man sich vor allem anschauen und natürlich hören, was sie kann und nicht, was sie nicht kann.
>> Mehr erfahren>> Alle anzeigenKategorie: Profi- / Musiker-Equipment
Ausstattungsliste: CODA Audio LINUS5-C
Specification | |
Type | 4 Channel DSP Amplifier with Loudspeaker Management |
General | |
Number of output channels | 4 |
Output stage | Class D |
Internal samplerate / bit-depth | 96 kHz / 24 bit |
Output-to-noise ratio (22 Hz – 20 kHz, 4 Ω – analogue input) | >112 dB (unweighted) |
>115 dB (A-weighted) | |
Signal-to-noice ratio (22 Hz – 20 kHz, 4 Ω – digital input) | >114 dB (unweighted) |
>117 dB (A-weighted) | |
Frequency response (8 Ω load with CLEAR preset) | 20 Hz – 20 kHz = (+0.5 dB /-1.0 dB) |
THD+N & IMD (4 Ω load @ 1/2 output power) | 20 Hz – 17 kHz = < 0.01% |
Latency (input to loudspeaker output) | Minimum 2.70 ms AES/EBU input |
Minimum 2.00 ms analogue input | |
Protection circuits | Inrush current limiter Thermal limiter Output DC SMPS over-current Output overload |
LED indicators | Mute status Limit 0 dB Signal Protection Ethernet control active Digital signal locked Power on |
Ethernet connection | 1 x 10 Mbps RJ45 |
AC Mains | |
AC mains input connector | Neutrik 32A powerCON® |
AC mains input voltage** (230 V internal jumper setting) | 180 V = Minimum |
230 V = Nominal | |
264 V = Maximum | |
AC mains input voltage** (115 V internal jumper setting) | 85 V = Minimum |
115 V = Nominal | |
132 V = Maximum | |
AC mains frequency | 47 – 63 Hz |
Power consumption (1/4 power = 600 W @ 4 Ω to represent typical music signal) | Amplifier in standby = 27 W |
Amplifier idle = 115 W | |
Amplifier ¼ power = 851 W | |
Input | |
Input sources | Analogue & AES/EBU |
Analogue input impedance (balanced) | 30 kΩ |
Maximum input level (analogue differential) | +15 dBu / 4.36 Vrms |
Input connections | 4x XLR3 Analogue IN |
1x RJ45 Analogue IN (4x CH) | |
1x RJ45 Analogue LINK (4x CH) | |
1x RJ45 Digital IN (4x CH) | |
1x RJ45 Digital LINK (4x CH) | |
Supported digital input formats (internal SRC) | 32 kHz / 44.1 kHz / 48 kHz / 88.2 kHz / 96 kHz / 176.4 kHz / 192 kHz |
Output | |
RMS output power (20 Hz – 20 kHz, THD <0.1%) (all channels driven) | 400 W @ 8 Ω |
700 W @ 4 Ω | |
900 W @ 2.7 Ω | |
1250 W @ 2 Ω | |
Peak output power (20 Hz – 20 kHz, 6 dB Crest Factor) (all channels driven) | 900 W pk @ 8 Ω |
1600 W pk @ 4 Ω | |
1700 W pk @ 2.7 Ω | |
1600 W pk @ 2 Ω | |
Maximum output voltage | +/- 85 V pk |
Maximum output current | +/- 38 A pk |
Damping Factor (8 Ω load, 1 kHz & below) | > 400 |
Minimum output load | 2 Ω nom |
Power output connections | 2x Neutrik NL4 speakON® |
1x Neutrik NL8 speakON® | |
Thermal | |
Operating temperature | +5°C to +55°C |
41°F to 131°F | |
Thermal output (BTU/h) | 307.09 = Idle |
665.37 = 20 % | |
1207.90 = 50 % | |
2108.70 = 100 % | |
Thermal output (kWh) | 0.090 = Idle |
0.195 = 20 % | |
0.354 = 50 % | |
0.618 = 100 % | |
Cooling | 2x thermally controlled fans |
Hot air expelled at rear | |
Physical | |
Dimensions (WxHxD) | 483.5 x 88 x 454.18 mm / 19.04” x 3.46” x 17.88” (2 Rack units) |
Net Weight | 10.7 kg / 23.6 lbs |