588_24248_2
Topthema: Audio System M-700.1MD, Audio System M-750.1MD 24V
Kleinstgeräte
Mit M-700.1MD und M-750.1MD 24V präsentiert Audio System Bassverstärker mit bisher nicht dagewesener Leistung auf kleinstem Raum.
>> Mehr erfahren>> Alle anzeigen
591_24427_2
Topthema: Mini-LED-TV TCL 55C6K
Qualität zum Kampfpreis
Der QD-Mini-LED-Fernseher TCL 55C6K bietet zum günstigen UVP von 800 Euro tolle Bildqualität auf 55 Zoll.
>> Mehr erfahren>> Alle anzeigenKategorie: Profi- / Musiker-Equipment
Ausstattungsliste: Manley NEO-CLASSIC SE/PP 300B
Ausstattung & technische Daten
| Specification | |
| Type | POWER AMPLIFIER |
| Vacuum Tubes | 2 x 300B (Output), 1 x 6SN7 (Driver), 1 x 6SL7 (Input), 2 x 5AR4 (Rectifier). (Units prior to 2011 used 5U4 rectifier tubes.) |
| Output Power @ 1kHz with 5 dB FeedBack in SINGLE-ENDED | 11 Watts @ 3% THD |
| Output Power @ 1kHz with 5 dB FeedBack in PUSH-PULL | 24 Watts @ 1.5% THD |
| Frequency Response with 5 dB FB in SINGLE-ENDED | 15 Hz - 15 kHz ±0.5 dB (measured at 5 watts) |
| Frequency Response with 5 dB FB in PUSH-PULL | 10 Hz - 20 kHz ±0.5 dB |
| GAIN SE Mode 0dB Feedback Setting | 30 dB |
| GAIN SE Mode 10dB Feedback Setting | 20 dB |
| Input Sensitivity with 5db FB SINGLE ENDED | 700mV for Maximum Power |
| Input Sensitivity with 5db FB PUSH-PULL | 450mV for Maximum Power |
| Input Sensitivity with 5db FB SINGLE ENDED | 165mV for 1V output into 8 Ohms |
| Input Sensitivity with 5db FB PUSH-PULL | 160mV for 1V output into 8 Ohms |
| S/N Ratio | SINGLE ENDED: 83.5dB Ref. 1W; 2.83v//8 Ohms,20KHz BW; 5dB FB. |
| PUSH-PULL: 85.4dB Ref. 1W; 2.83v//8 Ohms; 20KHz BW; 5dB FB. | |
| Dynamic Range | SINGLE ENDED: 94dB Ref. 3% THD; 20KHz BW; 5dB FB. |
| PUSH-PULL: 99.5dB Ref. 1.5% THD; 20KHz BW; 5dB FB. | |
| Input Impedance | 100 kOhm, direct coupled. |
| Optimum Speaker Load (switchable) | 4 to 12 Ohm range appropriate for 4 & 8 Ohm speakers |
| 12 to 20 Ohm range appropriate for 16 Ohm speakers | |
| Actual Output Impedance | SINGLE ENDED: 2.25 Ohms Actual |
| PUSH-PULL: 1.86 Ohms | |
| Damping Factor | SINGLE ENDED: 3.5 |
| PUSH-PULL: 4.3 | |
| Maximum Power Consumption | 240 Watts |
| Mains Voltage Frequency | 50~ 60Hz |
| Power transformer factory set for 100V, 120V or 220-240VAC operation for original destination country | |
| Operating Mains Voltage changeable with power transformer re-wiring and fuse value change. | |
| Mains Fuse 100-120VAC operation | MDA 3 Amp SLO-BLO Ceramic Time-Delay fuse |
| Mains Fuse 220-240VAC operation | MDA 1.5 Amp SLO-BLO Ceramic Time-Delay fuse |
| B+ Fuse | MDA 400 mA SLO-BLO Ceramic Time-Delay fuse |
| Badge Illumination | Units produced before 7/2003 use 8V, 0.3A "Fuse-Lamp" 1/4" X 1 1/4" - Serial numbers after NSEPP314 use LED illumination which probably wont burn out |
| Dimensions | W= 8.5, D= 23, H= 9 inches, Including projecting controls and parts |
| Minimum Mounting Surface Dimensions | Feet Footprint = W= 7.5" D= 18" |
| Shipping Weight | 41 lbs. each |
