Es gibt Lautsprecher und dann gibt es noch die LS3/5A. Sie spaltet sowohl ihre Hörer, als auch die, die sie gar nicht kennen. Warum das so ist? Nun, dafür muss man sich vor allem anschauen und natürlich hören, was sie kann und nicht, was sie nicht kann.
>> Mehr erfahren>> Alle anzeigenMit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenKategorie: Profi- / Musiker-Equipment
Ausstattungsliste: Yamaha EMX7
Type | Powermixer |
Outline | |
I/O | |
Eingänge | TOTAL 12 channels : 8 Mono (MIC/LINE), 4 Stereo (LINE) |
Phantom power | +48 V |
Ausgänge | SPEAKERS [A, B], AUX1 SEND, AUX2 SEND, STEREO OUT [L, R], REC OUT [L, R] |
Control and others | FOOT SWITCH : Effect Mute on/off |
Bus | Stereo: 1, AUX: 2 (Including FX) |
Input Channel Function | |
PAD | 30 dB (CH1-4) |
Hi-Z | Supported (CH4) |
HPF | 80 Hz, -12 dB/oct. (CH1–3) |
COMP | 1-knob COMP (CH1–4) |
EQ HIGH | 10 kHz +15 dB / -15 dB (Shelving) |
EQ MID | 2.5 kHz +15 dB / -15 dB (Peaking) |
EQ LOW | 100 Hz +15 dB / -15 dB (Shelving) |
On-board processors | DSP SPX Algorithm 24 programs, Feedback suppressor, Graphic equalizer, Speaker processor |
On-board amplifiers | Maximum output power @4ohms |
1kHz THD+N less than 10% (CEA2006) : 710 W + 710 W, 1kHz THD+N less than 1% (CEA2006) : 600 W + 600 W | |
Maximum output power @8ohms | |
1kHz THD+N less than 10% (CEA2006) : 500 W + 500 W, 1kHz THD+N less than 1% (CEA2006) : 400 W + 400 W | |
Level Meter | 2 × 12 points LED meter (-30, -25, -20, -15, -10, -6, -3, 0, +3, +6, +10, PEAK) |
General specifications | |
Frequency response | Input to SPEAKERS : +1 dB/-3 dB (40 Hz to 20 kHz), Input to STEREO OUT, AUX1 SEND, AUX2 SEND : +0.5 dB/-1 dB (20 Hz to 20 kHz) , refer to the nominal output level @ 1 kHz |
Total harmonic distortion | Input to SPEAKERS: MIC/LINE =LINE (CH1–4): 0.1% @ 10 W (40 Hz to 20 kHz), 0.04% @ 65 W (1 kHz) ; |
Input to STEREO OUT, AUX1 SEND, AUX2 SEND: MIC/LINE =LINE (CH1–4): 0.02% @ +14 dBu (20 Hz to 20 kHz), 0.007% @ +20 dBu (1 kHz), (THD+N, measured with 22 kHz LPF) | |
Hum & noise level | Equivalent input noise |
-117 dBu (Noise is measured with A-weighting filter) | |
Residual output noise | |
Input to SPEAKERS : -70 dBu(40Hz to 20kHz, STEREO MASTER LEVEL: min); Input to STEREO OUT, AUX1 SEND, AUX2 SEND : -82dBu(20Hz to 20kHz, STEREO MASTER LEVEL: min) (Noise is measured with A-weighting filter) | |
Crosstalk | -85 dB (1 kHz, Measured with 1 kHz band pass filter) |
Protection circuit | Load protection DC-fault |
Amplifier protection Over heat protection, Over current protection, Integral power protection | |
Power supply protection Over heat protection, Over current protection | |
Power requirements | AC 100-240V, 50Hz/60Hz |
Power consumption | 45 W (Idle) / 250 W (1/8 Power) |
Dimensions | W 465 mm (18 5/16") |
H 308 mm (12 1/8") | |
D 325 mm (12 13/16") | |
Net weight | 9.5 kg (20.9 lbs) |
Accessories | Owner’s Manual, Technical Specifications, AC power cord (2.5 m) |
Options | Foot switch: FC5, Rack-mount brackets: RK-EMX7 |
Others | Operating Temperature: 0 to +40˚C |
303-2039
Musikus Hifi |
318-2424
Elektrowelt 24 |
224-1309
Nubert electronic GmbH |