Es gibt Lautsprecher und dann gibt es noch die LS3/5A. Sie spaltet sowohl ihre Hörer, als auch die, die sie gar nicht kennen. Warum das so ist? Nun, dafür muss man sich vor allem anschauen und natürlich hören, was sie kann und nicht, was sie nicht kann.
>> Mehr erfahren>> Alle anzeigenMit diesen Chassis wollte ich schon immer mal etwas bauen. Dass ich sie allerdings jemals zusammen in einer Box haben würde, hätte ich dann doch wieder nicht erwartet – dass das Ganze so gut werden würde, dann schon eher.
>> Mehr erfahren>> Alle anzeigenKategorie: Profi- / Musiker-Equipment
Ausstattungsliste: Yamaha EMX2
Type | Powered Mixer |
Outline | |
I/O | |
Eingänge | TOTAL 10ch : Mono (MIC/LINE):4, Stereo(LINE):3 |
Phantom power | CH1, 2 : +30 V |
Ausgänge | SPEAKERS [L, R], MONITOR OUT [L,R], SUBWOOFER OUT |
Control and others | FOOT SW : Effect Mute on/off |
Bus | Stereo: 1, Effect: 1 |
Input Channel Function | |
PAD | 26 dB (CH1-4) |
Hi-Z | Supported (CH4) |
EQ HIGH | 8kHz +15dB / -15dB |
EQ MID | 2.5kHz +15dB / -15dB |
EQ LOW | 100Hz +15dB / -15dB |
On-board processors | DSP SPX Algorithm Reverb 4 programs, MASTER EQ (SPEECH to MUSIC), Feedback suppressor |
On-board amplifiers | Maximum output power @4ohms |
1kHz THD+N less than 10% (CEA2006) : 250 W + 250 W, 1kHz THD+N less than 1% : 110 W + 110 W | |
Maximum output power @8ohms | |
1kHz THD+N less than 10% (CEA2006) : 170 W + 170 W, 1kHz THD+N less than 1% : 110 W + 110 W | |
Level Meter | 6points (-20, -6, 0 , +3, +6, LIMITER) |
General specifications | |
Frequency response | Input to SPEAKERS : +1 dB/-4 dB (40Hz to 20kHz), Input to MONITOR OUT : +0.5 dB/-1.5 dB (20Hz to 20kHz) , refer to the nominal output level @ 1 kHz |
Total harmonic distortion | Input to SPEAKERS : 0.2 % @ 13.8 W (40Hz to 20kHz), 0.4 % @ 23.2W (1kHz), Input to MONITOR OUT : 0.05 % @ +10 dBu (20Hz to 20kHz) 0.009 % @ +20 dBu (1kHz), (THD+N, Measured with 22 kHz LPF) |
Hum & noise level | Equivalent input noise -115 dBu |
Residual output noise Input to SPEAKERS : -68 dBu (40Hz to 20kHz, MASTER: min), Input to MONITOR OUT : -99 dBu (20Hz to 20kHz, MONITOR: min) | |
Crosstalk | -80 dB (1 kHz, Measured with 1 kHz band pass filter) |
Protection circuit | Load protection DC-fault |
Amplifier protection Over heat protection, Over current protection | |
Power requirements | AC 100-240V, 50Hz/60Hz |
Power consumption | 35W (Idle) / 90W (1/8 Power) |
Dimensions | W 375 mm (14.8") |
H 147 mm (5.8") | |
D 220 mm (8.7") | |
Net weight | 4.2 kg (9.3 lbs.) |
Accessories | Owner’s Manual, Technical Specifications, Power Cord (2m) |
Options | Foot Switch: FC5, Mic Stand Adaptor: BMS-10A, Rack mount kit RK-EMX2 |
Others | Operating Temperature: 0 to +40˚C |
303-2039
Musikus Hifi |
318-2424
Elektrowelt 24 |
224-1309
Nubert electronic GmbH |