626_24571_2
Topthema: Kompaktlautsprecher · Mito Audio Vector
Liebe auf den ersten Blick
Es ist schlicht erstaunlich: Es tauchen immer wieder neue Hersteller von Lautsprechern auf. Das erfordert mindestens Mut, Überzeugung und, sofern man erfolgreich sein will, Können.
>> Mehr erfahren>> Alle anzeigen
589_24182_2
Topthema: Revox Studiomaster A200
Musik ist Geschmacksache, Klang nicht
So lautet der Slogan der Firma Revox. Eine Marke, die man wie wenige andere mit der Kombination aus Technik und Design verbindet. Die Studiomaster A200 ist dafür ein schönes Beispiel.
>> Mehr erfahren>> Alle anzeigenKategorie: Vollverstärker
Ausstattungsliste: Parasound HINT 6
Ausstattung & technische Daten
| Specification | |
| Power Output - Both channels driven | (0.9% THD, 20 Hz - 20 kHz) |
| 180 watts x 2 @ 8 Ω RMS | |
| 270 watts x 2 @ 4 Ω RMS | |
| Current Capacity | 45 amps peak per channel |
| Frequency Response | 10 Hz - 100 kHz, +0/-3 dB |
| 20 Hz - 20 kHz, +0/-0.5 dB | |
| Total Harmonic Distortion (THD) | < 0.01 %, average listening levels |
| < 0.05 %, 160 watts x 2 @ 8 Ω | |
| Interchannel Crosstalk | > 70 dB at 20 kHz |
| > 78 dB at 1 kHz | |
| Signal to Noise Ratio - IHF A-weighted | Line in: - 103 dB (input shorted) |
| Digital in: - 106 dB | |
| Amplifier Damping Factor | > 800 at 20 Hz |
| Preamplifier Stage Input Sensitivity | 300 mV in for 1 V at Preamp Output jacks |
| Total Preamp Stage Gain: 10 dB | |
| Max Output Unbalanced: 7 V | |
| Max Output Balanced: 9 V | |
| Power Amplifier Stage Sensitivity | 1 V at Bypass/Amp In for 28 V at Speaker Out |
| Total Amp Stage Gain: 28 dB | |
| Phono Stage Sensitivity / Input Impedance | MM: 41 dB / 47 k Ω |
| MC: 54 dB / 47 k Ω or 100 Ω | |
| High & Low Pass Crossover Slope | 12 dB per octave |
| Supported DAC Sampling Rates | USB: up to 384 kHz / 32-bit PCM |
| DSD Native: DSD 64, DSD 128, DSD 256 | |
| DSD over PCM (DoP) at 384 kHz | |
| Coax/Optical | up to 192 kHz / 24-bit PCM |
| Digital to Analog Converter | ESS Sabre32 Reference ES9018K2M |
| 384 kHz / 32-bit | |
| USB 2.0 Controller | Savitech SA9227, 384 kHz / 32-bit |
| Headphone Amplifier | Texas Instruments TPA6120A |
| Output Impedance 10 ohms | |
| XLR Pin Identification | 1 = Ground (Shield) |
| 2 = Positive | |
| 3 = Negative (Return) | |
| Input Impedance | Unbalanced: 24 k Ω |
| Balanced: 100 k Ω per leg | |
| Preamplifer Output Impedance | Unbalanced: 100 Ω |
| Balanced: 470 Ω per leg | |
| Power Requirement | Standby: 0.5 watts |
| Idling power: 70 watts | |
| Maximum: 750 watts | |
| 110-125 VAC 60 Hz or 220-250 VAC 50 Hz | |
| AC mains voltage is set on rear panel | |
| Dimensions | Width: 17-1/4" (437 mm) |
| Depth: 16-1/4" (413 mm) | |
| Depth, with cables 17-1/4" (437 mm) | |
| Height, with feet: 5-7/8" (150 mm) | |
| Height, without feet: 5-1/4" (133 mm), 3U | |
| Net Weight | 33 lb. (15 kg) |
